Panasonic TH-50PF9EK Operating Instructions Manual

Panasonic TH-50PF9EK Operating Instructions Manual Manual pdf 8 page image

8Connections1 212 12SERIALPC INAUDIOSLOT1 SLOT3PR /CR /R PB/C B/B Y/GAUDIOR LCOMPONENT/RGB INSLOT2AUDIODVI-D INWhen connecting the speakers, be sure to use only the optional accessory speakers.Refer to the speaker’s Installation Manual for details on speaker installation.– Cable fi xing bands Secure any excess cables with bands as required.Pass the attached cablefixing band through theclip as shown in thefigure.To secure cables connected to Terminals, wrap the cable fixing band around themthen pass the pointed end through the locking block, as shown in the figure.While ensuring there is sufficient slack in cables to minimize stress (especiallyin the power cord), firmly bind all cables with the supplied fixing band.To tighten: To loosen:PullPullPush the catchNote:At factory shipment, Terminal board is installed in SLOT 2 and SLOT 3.Optional TerminalBoard Insert Slot(covered)COMPONENT/RGB INand Audio IN Terminals(see page 11)From EXTERNALmonitor terminal onComputer (see page 9)From SERIAL Terminalon Computer(see page 10)DVI-D INTerminals(see page 11)SPEAKERSTerminals (R)SPEAKERSTerminals (L)Speakers (Optional accessories)AC cord connection (see page 12)– AC cord fi xing3. Slide up the clamper and fixthe AC cord plug securely.2. I n s e r t t h e A C c o r dand close the clampersecurely.1. Open the clamper.Clamper AC cordNote: The power plug in the illustration may not be the type fitted to your set.When loosenthe clamper:4. Insert the point of thefixed clamper into thesmall hole on the lowerr i g h t o ft h e b a c kc o v e r a snecessary.