Panasonic TH-50PF9EK Operating Instructions Manual

Panasonic TH-50PF9EK Operating Instructions Manual Manual pdf 24 page image

24Picture AdjustmentsNotes:• “Colour” and “Tint” settings cannot beadjusted for “RGB/PC” and “Digital”input signal.• You can change the level of eachfunction (Contrast, Brightness, Colour,Tint, Sharpness) for each PictureMode.• The “Tint” setting can be adjustedfor NTSC signal only during “AV(S Video)” input signal.• In Contrast, there is not a noticeablechange even when contrast isincreased with a bright picture orreduced with a dark picture.Advanced settingsOn the remote control unit, while the “Advanced settings” menu is displayed, if either the N button is pressed at any time orthe ACTION ( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.Helpful Hint ( / Normalise Normalisation)Item Effect AdjustmentsContrast Less MoreSelects the proper brightness anddensity for the room.Brightness Darker BrighterAdjusts for easier viewing of darkpictures such as night scenes andblack hair.Colour Less More Adjusts colour saturation.Tint Reddish Greenish Adjusts for nice skin colour.Sharpness Less More Adjusts picture sharpness.Item Effect DetailsBlackextension Less MoreAdjusts the dark shades of the image in gradation.Input level Less MoreAdjustment of parts which are extremely bright and hard to see.(This cannot be adjusted when the input signal is Digital.)W/B HighR Less More Adjusts the white balance for light red areas.W/B HighB Less More Adjusts the white balance for light blue areas.W/B Low R Less More Adjusts the white balance for dark red areas.W/B Low B Less More Adjusts the white balance for dark blue areas.Gamma Down Up S Curve 2.0 2.2 2.5AGC Off On Increases the brightness of dark signal automatically.Notes:• Carry out “W/B” adjustment as follows.1. Adjust the white balance of the bright sections using the “W/B High R” and “W/B High B” settings.2. Adjust the white balance of the dark sections using the “W/B Low R” and “W/B Low B” settings.3. Repeat steps 1 and 2 to adjust.Steps 1 and 2 affect each other’s settings, so repeat each step in turn to make the adjustment.• The adjustment values are memorized separately for each input terminal.• The adjustment range values should be used as an adjustment reference.