Panasonic SC-ALL9 Operating Instructions Manual

Also see for SC-ALL6: Quick setup guide

Contents

Panasonic SC-ALL9 Operating Instructions Manual Manual pdf 8 page image

8 SQT1211≥ The following steps are based on asmartphone.≥ Do not connect a LAN cable. Doing so willdisable the Wi-Fi function.1 Turn this unit on.2 Go to Wi-Fi settings on the device.≥ Proceed to the next step after the network indicatorchanges from blinking in blue and red to blinkingslowly in blue§.§ The blinking in blue starts after approximately1 minute. If the blinking in blue does not start,perform a network reset. (l 9)3 Select “AllPlay _AJ” toconnect to this unit.≥ “” stands for a character that is unique to each set.≥ This can take up to 1 minute to appear in your Wi-Filist.≥ If this operation does not work correctly, pleaserepeat it several times.≥ Make sure that DHCP is enabled for the networksetting on your compatible device.[iOS_device]: The settings page will be automaticallydisplayed in the Internet browser.[Except_iOS_device]: Open the Internet browser andrefresh the page to display the settings page.≥ If the settings page is not displayed, type “http://172.19.42.1/” into the URL address field.4 Type a device name and then select“Next”.≥ The device name will be displayed as this unit’sname on the network.≥ The guaranteed limit is 32 characters.≥ The device name is set when “Next” is selected.≥ You can also change the device name after thenetwork connection is set up. (l 10)5 Select your network name (SSID)and type the password.≥ Check the wireless router for the network name(SSID) and the password.≥ A list of network names (SSIDs) will be appearedwhen you select the “Network Name” box.≥ To show the characters typed in the “Password”box, select “Show Password”.≥ If your network requires specific settings, deselect“DHCP” to disable DHCP.– You can use specific IP address, subnet mask,default gateway, primary DNS, etc.≥ To update the network name (SSID) list, select“Refresh list”.6 Select “Connect” to apply thesettings.≥ When the connection is established, the networkindicator (blue) lights up.≥ Depending on the device, the connection completescreen may not be displayed.7 Make sure to connect yourcompatible device back to yourhome wireless network.≥ Enable Java and cookies in your browser settings.Using an Internet browserSettings Wi-Fi SettingsAllPlayIf the network indicator does not light up,check the network name (SSID) and thepassword, and then try the setting again.* Network NameRefresh list* PasswordShow PasswordDHCP●●●●●●●●