Panasonic SC-ALL9 Operating Instructions Manual

Also see for SC-ALL6: Quick setup guide

Contents

Panasonic SC-ALL9 Operating Instructions Manual Manual pdf 27 page image

SQT1211 27[SC-ALL9] [SC-ALL6]≥ Specifications are subject to change without notice.≥ Mass and dimensions are approximate.≥ Total harmonic distortion is measured by a digitalspectrum analyzer.§1 Prospect communication distance.Measurement environment.(Temperature 25 o C, Height 1.0 m)Measure in “Mode1”§2 Uncompressed FLAC files may not operatecorrectly.∫ Bluetooth ® SECTIONVersionBluetooth ® Ver.3.0OutputClass 2 (2.5 mW)Correspondence profileA2DPCommunication method2.4 GHz band FH-SSProspective Communication distanceApprox. 10 m§1∫ Wi-Fi SECTIONWi-FiWLAN Standard IEEE802.11a/b/g/nFrequency range 2.4 GHz band (1-11 ch)/5 GHz band (36-165 ch)Security WPA2TMWPS version Version 2.0∫ Audio support format (AllPlay)MP3/AACSampling frequency 32/44.1/48 kHzAudio word size 16 bitsChannel count 2 chBit-rate 8-320 kbpsFLAC§2 /ALAC/WAVSamplingfrequency32/44.1/48/88.2/96/176.4/192 kHzAudio word size 16 bits/24 bitsChannel count 2 chDeclaration of Conformity (DoC)Hereby, “Panasonic Corporation” declares that this product isin compliance with the essential requirements and otherrelevant provisions of Directive 1999/5/EC.Customers can download a copy of the original DoC to ourR&TTE products from our DoC server:http://www.doc.panasonic.deContact to Authorised Representative:Panasonic Marketing Europe GmbH, Panasonic TestingCentre, Winsbergring 11, 22525 Hamburg, GermanyThis product is in compliance with the radio standards of thefollowing countries.GB, DE, AT, BE, DK, SE, FR, IT, ES, NL, FI, GR, PT, PL, HU,CZ, SK, EE, LV, LT, SI, BG, RO, MT, CY, IE, LU, HR, NO, CH,IS, LI, TRThis product is intended for general consumer. (Category 3)The WLAN feature of this product shall exclusively be usedinside buildings.This product on purpose to connect to access point of2.4 GHz or 5 GHz WLAN.Class II equipment (The construction of the productis double-insulated.)[SC-ALL9]Product Identification Marking is located on the bottom ofthe unit.[SC-ALL6]Product Identification Marking is located on the rear ofthe unit.