SYSTEM MAINTENANCE AND TROUBLESHOOTINGInstallation Manual 167Notes• The data terminal that you use must be equipped with communications software thatsupports the Xmodem file transfer protocol. The command can be canceled by Typing[\] before entering the sending mode. Once the sending mode has been selected, usethe cancel command of the communication software being used.• If your data terminal supports a high speed, it is recommended that you LOAD at themaximum speed of 38400 bps. First, change the RS-232C setting of the VPS (seeB7.1 RS-232C Parameters). Next, change the RS-232C setting of your data terminalto the same speed.7.2.9 Print All of the VPS Parameters (GPRN)Use the GRPN command to print all VPS parameter settings (output to screen). Use Ctrl-C atany time to stop printing.Type GPRN, then Press RETURN.NoteThis command is only valid when in the ASCII TERMINAL mode.7.2.10 Program Version Display (VERS)Use the VERS command to display the version numbers of the flash memory and main ROM.Type VERS, then Press RETURN.$ GPRN0: All Parameters1: Mailbox Setting2: Class of Service Setting3: Port/Trunk Service Setting4: Service Setting - Auto Attn. Setting5: Service Setting - Custom Service Setting6: Service Setting - Caller ID Call Routing7: System Parameter Setting - System Group Assignment8: System Parameter Setting - Time Service, Holiday, Daylight Saving Time9: System Parameter Setting - Prompt Setting10: System Parameter Setting - System Caller Name Announcement11: System Parameter Setting - Others12: Hardware Setting13: System Reset Clear ParameterPlease select : =$ VERSV.P.S. PROGRAM VERSIONMAIN FLASH MEMORY : VP21AA (4.12)MAIN ROM : VP01AA (2.01)
