INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBXInstallation Manual 73NoteDepending on the model and/or the software version of the connected PBX (see 3.1.1 APT/DPT or Inband Signaling?), you may not be able to utilize some of the features listed above.For more information, call National Parts Center at 1-800-833-9626.Intercom Paging* Callers can page subscribers through built-in speakersand external paging equipment. For a Caller ID Caller,if his name has been recorded for the Caller NameAnnouncement feature, the name will be announced atthe end of the page.Caller Name Announcement(System/Personal)*The VPS announces the prerecorded Caller ID callers’names when: (1) extension users listen to messagesfrom assigned numbers left in their mailboxes, (2) theVPS transfers calls from assigned numbers to theusers, and (3) the VPS pages the users by intercom.If the same Caller ID number is programmed for bothsystem and personal caller name announcements, theVPS will use the personal caller name.Caller ID Call Routing* The VPS automatically sends calls from pre-assignedCaller ID numbers to the desired extension, mailboxor Custom Service.Personal Greeting for Caller ID* Each subscriber can record up to 4 personal greetingmessages for special callers.Time Synchronization(DPT Integration only)Whenever the PBX sets a new date and time or whenDPT Integration is established, the data isautomatically registered in the VPS.* Caller ID Note 1: When an incoming outside call reaches the VPS via thePBX, the VPS will wait about 2 rings before answering the call to receive theCaller ID information properly from the PBX.This waiting time can be changed by using the WCID command (see7.2.20 Wait for Caller ID (WCID) in 7.2 UTILITY COMMANDS).Caller ID Note 2: In the documentation for the KX-TD816/1232 series PBX,the Caller ID feature is called CLIP (Calling Line IdentificationPresentation).Table 13DIGITAL INTEGRATION FEATURES
