SYSTEM MAINTENANCE AND TROUBLESHOOTING172 Installation Manual7.2.17 Quick Setup (QSET)Use the QSET command initially to setup the VPS very roughly when you use it for the firsttime or after system initialization.NoteQuick setup requires VT100 emulation software.Type QSET, then Press RETURN.7.2.18 Circuit Condition Display (LMON)Use the LMON command to display the circuit condition every 1.5 s. To turn off thiscommand, enter [\].The following circuit conditions may be displayed.7.2.19 Touchtone Information Display (PUTD)Use the PUTD command to display the touchtones the VPS receives and sends.In addition to the touchtones, the following will be displayed—the Incoming Call Service(Voice Mail, Automated Attendant, Custom, and Interview) entered by the caller and the timeperiods that the ports are enabled.Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The defaultsetting of this mode for all ports is "OFF"."Ready" : Possible to serve"Incoming Call" : Processing arrival service"Outgoing Call" : Processing sending service"DSP Reset" : Processing DSP reset disposition"PT connect" : Processing PT connect disposition"Error" : DSP Card is not loaded$ LMONNo.:1: Ready2: ReadyStatus$ PUTDTarget Port : **Don't leave enabled after troubleshooting.$
