VOICE PROCESSING SYSTEM OVERVIEW18 Installation Manual* For Panasonic KX-TD series telephone systems with DPT IntegrationTo change the position, use a pointed object, such as a pen, etc.Hard Disk Drive:(One/system) Stores the proprietary system programme, the system administration table, andthe voice prompts (about 50 min worth); has the recording area for the messages from callers.(The hard disk is controlled by the central micro processor.)Note: The actual Hard Disk Drive mounted on your VPS may look different from the oneshown in the corresponding illustration provided in the beginning of this section.CPU Board:(One/system) Main processing unit for the system. Comprised of central microprocessor,ROM, dynamic RAM, system controller, Rotary Switch, and an RS-232C interface.1.3.3 Which Phone Systems are Compatible?We recommend integration with the following Panasonic phone systems:• Panasonic KX-TD500• Panasonic KX-TD1232• Panasonic KX-TD816• Panasonic KX-TA series7 Reserved8 Initializes the VPS. Clears all voice data andreturns all system parameters to the default setting.CAUTION: User 1 and User 2 Prompts will beerased!9 ReservedWhen setting the Rotary Switch to any position (except 0):1. Disconnect the station wire(s) and wait a few minutes.2. Turn the power switch off at the VPS.3. Set the Rotary Switch.4. Turn the power switch back on at the VPS.5. Connect the station wire(s) to the VPS and wait approximately 5 min.6. Return the Rotary Switch to position 0.Table 1Position Additional Function
