2.6 UtilityPC Programming Manual 872.6.14 Utility—CS InformationDisplays information stored by the PBX regarding each Cell Station (CS).This option is only available at Installer level, and requires that the target CSIF, DHLC or DLC card beset to INS status.The displayed items are as follows:To view CS information1. From the Utility menu, select CS Information.2. From the Target CSI/F Slot No drop-down list, select the target slot.• To display information on a single card, select the slot number and name of that card.• To display information on all matching cards, select "ALL".3. From the Interval Timer drop-down list, select the number of seconds between each automaticscreen refresh.4. Click Start to begin monitoring.Monitoring will be performed and the screen will refresh according to the interval specified.To refresh the screen manually at any time, click Refresh.5. Click Stop to end monitoring.6. Select an option:• Click Capture if you want to save the displayed information.1. Enter a file name, or select a file to overwrite.Item DescriptionShelf-Slot Number of the slot (for KX-TDA600, shelf and slot)Port Number of the portCS Name Name of the attached CSStatus Service status of the attached CS: INS, OUS, or FAULT.If the status is FAULT, subsequent data items for that port will be leftblank.Version Version number of the program file stored in the CSRevision Revision number of the program file stored in the CSCSID 12-digit ID number of the CSPath Number of the wireless extension currently using each path. In thecase of a group, several extensions may be using the same floatingextension number.When an extension number is not registered, the display shows"OFF". 2.4 GHz PSs can use up to 3 paths (KX-TDA100/KX-TDA200/KX-TDA600) or 2 paths (KX-TDA30). DECT PSs can useup to 4 paths (KX-TDA100/KX-TDA200/KX-TDA600) or 2 paths(KX-TDA30). When using high-density CSs, DECT PSs can use upto 8 paths.Group Call Number of PSs registered to the attached CS that are members ofa PS Ring Group.
