2.9 [2] System404 PC Programming Manual2.9.9 [2-6-2] Numbering Plan—Quick DialQuick Dialling numbers are used to call extensions or outside parties, or access certain featureswithout having to dial their full numbers. It is possible to register Quick Dialling numbers that overlapwith other registered numbers (refer to "Automatic Rerouting of Calls via a Private IP Network toPublic Trunks" in the Feature Guide).A maximum of 80 Quick Dialling numbers can be programmed. When an EMEC/MEC card is installedin the PBX, a maximum of 4000 (with the KX-TDA100/KX-TDA200/KX-TDA600) or 1000 (with the KX-TDA30) Quick Dialling numbers can be programmed. To display other sets of numbers, click theapplicable tab.For more information on flexible numbering, see "2.3.6 Flexible Numbering/Fixed Numbering" in theFeature Guide.Use quick dial for rerouting to public CO when TIE line does not workSpecifies whether to check if the quick dial numbering plan is compatible (does not overlap) with themain numbering plan.Value RangeDisable: Checks whether the quick dial numbering plan is compatible with the main numbering plan.Enable: Does not check whether the quick dial numbering plan is compatible with the main numberingplan.Maintenance Console Location2.9.9 [2-6-2] Numbering Plan—Quick DialProgramming Manual ReferencesNoneFeature Guide References1.6.1.6 Quick Dialling1.30.2 Voice over Internet Protocol (VoIP) Network2.3.6 Flexible Numbering/Fixed NumberingDialSpecifies the Quick Dialling number.Value RangeBasic Memory: Max. 4 digits (consisting of 0–9, *, and #)MEC expansion memory: Max. 8 digits (consisting of 0–9, *, and #)Maintenance Console Location2.9.9 [2-6-2] Numbering Plan—Quick DialProgramming Manual ReferencesNone
