2.17 [10] CO & Incoming Call782 PC Programming Manual2.17.7 [10-5] MiscellaneousThe Intercept Routing feature can activate when the destination of an incoming call is unavailable, orwhen there is no destination for the call, to reroute the call to an alternate destination.Intercept—Intercept Routing - DND (Destination sets DND)Enables the Intercept Routing—DND feature to activate when the original destination is in DNDmode.Value RangeDisable (Busy Tone): Sends a busy tone to the caller. (However, a call through an LCOT/ELCOT orT1 [LCOT/GCOT] card will ring at the original destination while the caller hears a ringback tone.)Enable: Redirects the call to the intercept destinationMaintenance Console Location2.17.7 [10-5] MiscellaneousProgramming Manual ReferencesNoneFeature Guide References1.1.1.6 Intercept Routing1.3.1.3 Do Not Disturb (DND)Intercept—Routing to Operator - No Destination (Destination is notprogrammed)Enables the Intercept Routing—No Destination feature to activate when there is no destination for thecall. (The Intercept Routing—No Destination feature always works for calls through an LCOT/ELCOTor T1 [LCOT/GCOT] card, even when this feature is disabled.)Value RangeDisable (Reorder Tone): Sends a reorder tone to the callerEnable: Redirects the call to an operatorMaintenance Console Location2.17.7 [10-5] MiscellaneousProgramming Manual ReferencesNoneFeature Guide References1.1.1.7 Intercept Routing—No DestinationIntercept—Intercept Routing for Extension CallEnables the Intercept Routing feature to operate for extension calls.
