2.2 Start Menu42 PC Programming Manual2.2.5 Start Menu—Connect—LANConnects to the PBX in Interactive mode through the Local Area Network interface of the PBX.A CTI-LINK card (KX-TDA100/KX-TDA200/KX-TDA600) or IP-GW4 card (KX-TDA30) must beinstalled and the IP address of the PBX set to use this feature. For more details, see 2.8.44 [1-1]Slot—Card Property - CTILINK (KX-TDA100/KX-TDA200/KX-TDA600 only) and 2.8.33 [1-1]Slot—Card Property - IP Gateway (KX-TDA30 only).This option allows direct entry of connection parameters, for cases where the PC is used to connectto one or just a few PBXs, and an individual profile for each PBX is not necessary. If you connect tomultiple PBXs and would prefer to choose from among pre-saved profiles instead, see 2.2.8 StartMenu—Connect—Profile Setup for more details about creating profiles.To connect to the PBX by LAN1. From the start menu, select Connect.The Login window will be displayed.2. Select a connection option.• Select a Profile Name if you want to use a pre-saved profile.a. Select the profile to use from the drop-down list.b. If the system password for the PBX has not been stored with the profile, enter it.If the system password has been stored with the selected profile, it does not need to beentered.• To enter the parameters manually, select the PBX Model and confirm that the LAN radiobutton is selected.a. Specify the connection parameters as required. For more details, see the table below.b. Enter the system password for the PBX.3. Click Connect.Connection Settings for LANSetting Values ExplanationIP Address 1.0.0.0–223.255.255.255Specify the IP address of the PBX on the LAN.Enter the same IP address that was input in IPAddress of 2.8.44 [1-1] Slot—Card Property- CTILINK (KX-TDA100/KX-TDA200/KX-TDA600 only).Port Number 1–65535 Specify the port number used to access thePBX via LAN. Enter the same port number thatwas input in Maintenance Port Number of2.8.44 [1-1] Slot—Card Property - CTILINK(KX-TDA100/KX-TDA200/KX-TDA600 only)or 2.8.33 [1-1] Slot—Card Property - IPGateway (KX-TDA30 only).
