2-2 Station Programming (Personal Programming)2.1 Station Programming InstructionsStation Programming allows you, the proprietary telephone (PT) users, to program certainfeatures from your telephone individually. To program, you need to switch yourtelephone to the Station Programming mode. During programming mode, your telephoneis in the busy condition to outside callers. If you want to make a normal call handlingoperation, you must finish the programming mode.Programming Mode DisplayWhen you enter the Station Programming mode, the display shows the following messageas the initial programming mode;The display also gives you helpful or stored data information related to yourprogramming steps. In this section, we note the display example in the programmingsteps, if required. You can also refer to the “Display Examples” in the Appendix(Section 8).To enter the Station Programming modeBe sure the telephone is idle and on-hook.1. Press the PROGRAM button.2. Dial 99.• If 99 is not dialed within 5 seconds of pressing thePROGRAM button, the Station Programming mode iscanceled.• The display shows:(— initial programmingdisplay)• The STORE indicator lights.• If there is no entry within one minute, the StationProgramming mode is canceled. Normal call handlingresumes.To exit the Station Programming modeWhen the display shows the initial programming mode;1. Press the PROGRAM button or lift the handset.• Programming is completed and normal call handlingresumes.• If you go off-hook while programming, the mode is canceledand normal call handling resumes.121or9PROGRAMPROGRAMPT-PGM ModePT-PGM Mode9
