4-50 DPT FeaturesC 4.2 DPT FeaturesTo talk to the original party while holding the third party1. Press the TRANSFER button.• You hear a confirmation tone (optional).• If both of the other parties are extensions, the INTERCOMindicator light flashes green moderately.To put both parties on hold1. Press the HOLD button.• This feature is only available when at least one party is on anoutside line.Conditions• Up to six conference calls are allowed simultaneously.• A conference call can also be established by “Executive Busy Override” or “PrivacyRelease”.• Pressing a CO button which is not in the conference, allows you to exit from theconference leaving the other two parties connected unless they are both outside lines.If the other parties are both outside lines, they will be disconnected.• You can return to the original party before the third party answers by pressing theTRANSFER button.• A flexible button on the KX-T7250 (no CONF button provided) can be assigned as theCONF button.• When a two-party call is changed to a three-party call or vice versa, a confirmation toneis sent to all three parties. Eliminating the tone is programmable.Programming References• Station Programming (Section 2)Flexible CO Button Assignment — Conference (CONF) Button(System Programming — [005] (Installation Manual) can be used for this assignment.)• System Programming — Installation Manual[990] System Additional Information, Field (13)Feature ReferencesConference, UnattendedExecutive Busy Override — ExtensionExecutive Busy Override — Outside LinePrivacy Release1 HOLD1TRANSFER
