Panasonic KX-TCD560E Operating Instructions Manual

Also see for KX-TCD560E: Operating instructions

Panasonic KX-TCD560E Operating Instructions Manual Manual pdf 31 page image

Useful Telephone Settings31Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333Base unit settingsAdjusting ringer volume1 Press $ (centre of joystick).2 Select u, then press ,.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page32).4 Press , 2 times.5 Push the joystick up or down repeatedlyto select the desired volume.6 Press ,.7 Press {ih}.Call OptionsChanging the recall modeChange the recall mode, if necessary,depending on the requirements of yourservice provider or PBX.Important:L If this unit is connected to a PBX, anoptional earth relay may need to beinstalled. Please consult our PanasonicCustomer Care Helpline for moreinformation. After installation you mayselect flash or earth mode to suit therequirements of your PBX or serviceprovider.1 Press $ (centre of joystick).2 Select u, then press ,.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page32).4 Select “Call Option”, then press, 2 times.5 Select the desired setting, then press,.L If “Flash” is selected, next selectflash type 1, 2, or 3, then press ,.“Type 1”: 700 ms“Type 2”: 80 ms“Type 3”: 400 ms6 Press {ih}.Setting pause lengthChange the pause length, if necessary,depending on the requirements of yourservice provider or PBX.“Short”: 3 sec.“Long”: 5 sec.1 Press $ (centre of joystick).2 Select u, then press ,.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page32).4 Select “Call Option”, then press,.5 Select “Pause Time”, then press ,.6 Select the desired setting, then press,.7 Press {ih}.Storing/changing emergency numbersThese settings determine which phonenumbers can be dialled while the call barfeature is on (page 27).1 Press $ (centre of joystick).2 Select u, then press ,.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page32).4 Select “Call Option”, then press,.5 Select “Emergency Call”, then press,.6 Select a memory location, then press,.L If the memory location alreadycontains an emergency number, thenumber is displayed.7 Enter/edit the number, then press ,.