4-82 System Programming[800] 4.2 System ProgrammingAssigns the communication parameters for the Serial Interface (RS-232C).NL–Code: Selects the code for your printer or personal computer. If your printer orpersonal computer automatically feeds lines with a carriage return, select“CR”. If not, select “CR+LF”.Baud Rate: The baud rate code indicates the data transmission speed from the systemto the printer or personal computer.Word Length: The word length code indicates how many bits compose a character.Parity: The parity code indicates what type of parity is used to detect an error inthe string of bits composing a character. Make your selection dependingon the requirements of your printer or personal computer.Stop Bit: The stop bit code indicates the end of a bit string which composes acharacter. Select a value depending on the requirements of your printeror personal computer.*1 CR+LF (Carriage Return + Line Feed) / CR (Carriage Return)*2 Select “None” when the error checking function is not required from the printer.Default New line Baud rate Word length Parity Stop bit lengthCR + LF 9600 baud 8 bits Mark 1 bit• To return to the previous mode, press instead of .• The following combinations are invalid.If any of the above invalid combinations are selected, an alarm tone is heard.• Feature ReferenceSection 3, FeaturesStation Message Detail Recording (SMDR)NEXTPREV008[800] SMDR RS-232C Communication ParametersNEXT SELECTEND(CR+LF/CR)*1STORE NEXT SELECT(150/300/600/1200/2400/4800/9600 B)STORENEXT SELECT STORE NEXT SELECT(Mark/Space/Even/Odd/None*2 )STORE(7/8 bits)NEXT SELECT STORE(1 bit/2 bits)< Sets the new line code> < Sets the baud rate >< Sets the word length > < Sets the parity > < Sets the stop bit length >!! Word length888ParityMarkSpaceSpace+Stop bit length212(New line)
