System Programming 4-454.2 System Programming [402]-[403]If the system is installed behind a host PBX, each exchange line may require an access codeto make an outside call. Up to 8 access codes can be stored for each exchange line. Whenthe programmed codes are dialled, the pause time assigned in program [417] “Pause Time”is automatically inserted, and call barring is applied after the code.*1 Exchange line number: 1 through 6 / (All exchange lines)*2 Insert a “,” for each code using the button on the overlay.Example:• Access codes 81, 82 on exchange line number 1Default All exchange lines – Not stored• To correct a wrong entry, press the CLEAR button and enter the new one.• Feature ReferenceSection 3, FeaturesHost PBX Access,Selects a pulse rate for each exchange line which sets “Pulse Mode” or “Call block Mode” inprogram [401] “Dial Mode”. There are 2 pulse rates, Low Speed (10 pps) and High Speed(20 pps).* Exchange line number: 1 through 6 / (All exchange lines)Default All exchange lines – Low Speed04[402] Pulse Speed Selection304[403] Host PBX Access CodesNEXT STORE ENDaccess code*2Up to 8 access codes1 or 2 digits(0···9)304 NEXT STORE END1 8 81 , 2(Low/HighSpeed)exchange line no.*1To continue(1 ··· 6/ )(1 ··· 6/ )2 NEXT SELECT ENDexchange line no.*NEXT PREVorSELECTTo continueTo continueSTORENEXT PREVorTo continue!!+SELECT
