Connecting to the Rear Speaker TerminalsConnect after turning the power of the TV OFFPress the Right Speaker red button and insert the positive lead wire (+) into the hole above the button. When the button is released,the wire is locked into place. In same manner, press the Right Speaker black button and insert the negative lead wire (-). Repeat thisprocedure for the Left Speaker.DOLBY SPEAKERSSPEAKER EARF_I_RKER .®INT./EXT. SPEAKERINT.EXT.S_ONLY®J OTE: Model CT-35S21 has only one rear speaker terminal while 0T-35S31 has two rear speaker terminalsQ DOLBY SURROUND EXTERNAL CONNECTION (0T-35S31 only)This is used for Dolby Surround and sound signal is always "ON".(_ INT/EXT. SPEAKER CONNECTION (CT-35S31 and CT-35S21)This is controlled by the Remote Control through the On Screen display. It can be turned "ON" or "OFF" with theINT./EXT. switch that could be set to built-in Internal speaker or an Optional Ext. speaker connection.CAUTION: Do not connect speakers simultaneously to the REAR SPEAKER terminal of the Color TV and Amplifier. This could damageboth the Color TV and the Speakers. Your Color TV was designed to use 8Q speakers only. Any other type may degradethe audio performance of your entertainment system.SOLID STATE COLOR TV SPEAKER AMPLIFIERTips on Rear Panel ConnectionsThe S-VIDEO connection is provided for high performance laser discs, VCR's etc., that have this feature. Use this connection in place ofthe standard video connection if your device has this feature.If your device has only one audio output, connect it to the left audio jack on the IV.Refer to the operating guide of your other electronic equipment for additional information on connecting your hook-up cables.A single VCR can be used for VCR #1 and VCR #2 but note that a VCR cannot record its own video or line output (Input 1 in the exampleon pages 47 & 48). Refer to your VCR operating guide for more information on "line" input-output connections.-50-