Clip Management: Checking Card Status 65Clip ManagementAfter completing the settings described on the previous page,you can use the procedure described below to check thestatus of P2 cards in P2 card slots.1 Open the thumbnail screen.2 Press the MENU button.3 Use the cursor buttons to choose [PROPERTY] –[CARD STATUS] and press the SET button todisplay P2 card status.1) Write protect markA write-protected P2 card is indicated by the markdisplayed here.2) P2 card statusThe remaining free memory on the P2 card isdisplayed here in the form of a bar meter and apercentage value.Memory used on the P2 card is also displayed in theform of a bar meter and a percentage value.The following status information may also appeardepending on card status.3) P2 card remaining memory (or memory used)/totalmemoryIndicates P2 card remaining free memory (or memoryused)/total memory in time left in minutes. Fractions ofa minute are rounded off on the display so that the sumtotal of the remaining memory available for recordingon each P2 card may not tally with the figure for thetotal memory.4) Slot remaining memory (or memory used) totalThe figure obtained by totaling the remaining freememory on the six P2 slots is shown here.◆ NOTE:• Free space of write-protected P2 cards is not included inthe free space total.5) Detailed P2 card statusSelect the slot of the P2 card whose status you want tocheck and press the SET button to view the P2 cardmodel number and other detailed information.Press the SET or EXIT button again to close thedetailed information screen.Displaying Card Status Information3)2)1)4)5)6)orFORMAT ERROR: An unformatted P2 card isinserted.NOT SUPPORTED: This unit does not support theinserted card.NO CARD: No P2 card has been inserted.
