|
30 Introduction: Control Reference Guide1. SD/SDHC Memory Card SlotInsert an SD/SDHC memory card.Insert the card with the label side facing up and theend with the corner cut off facing in. Push in the carduntil it locks into place. To remove the card, first makesure that the lamp is not on, then push it in the directionof insertion to release the lock.◆ NOTE:• Do not insert any cards other than SD/SDHC memorycards.• This unit uses only SD/SDHC memory cards that complywith the SD/SDHC specifications. Other memory cardssuch as MultiMediaCard cannot be used. When using aminiSD card, be sure to use an adaptor dedicated for usewith the miniSD card to insert the card into the SD MemoryCard Slot.* MultiMediaCard (MMC) is a registered trademark ofInfineon Technologies AG.* The SDHC (SD High Capacity) card is a new standard,established by the SD Card Association in 2006, forlarge-scale memory cards with capacities above 2 GB.• To format an SD card on a PC, use the following softwarethat can be downloaded from the support sites listedbelow.• This unit supports the following SD and SDHC memorycard capacities.SD (8 MB to 2 GB): 8 MB, 16 MB, 32 MB, 64 MB, 128 MB,256 MB, 512 MB, 1 GB, 2 GBSDHC (4 GB to 16 GB): 4 GB, 8 GB, 16 GB• For the latest information not available in the OperatingInstructions, visit the P2 support desk at the following Websites.For English: https://eww.pavc.panasonic.co.jp/pro-av/• The term “SD memory card” will be used below as ageneric for SD and SDHC memory cards.2. USB 2.0 connector (Type A)Connect P2 store and USB 2.0 compliant hard diskdrives for use in the USB host mode.➝Refer to “Using USB Connectors” (page 103).3. USB 2.0 connector (Type B)Connect personal computers and other devices foruse in the USB device mode.➝Refer to “Using USB Connectors” (page 103).◆ NOTE:• Use double shielded cable for making connections to USB2.0 connectors.• Attach the supplied ferrite cores near the cable connectorat each cable end when making cable connections to theUSB 2.0 connector.Side Panel21 3
|
