114 Using USB Connectors and SD/SDHC Memory Cards: External Remote ControlRegistering IN and OUT points makes possible automaticrecording (AUTO CAPTURE) between those two points.1 Enter the mode that permits control of externaldevices.Press the EVENT button when the THUMBNAIL and PLAYLIST buttons are off.2 Select an area for capture.• Use the following buttons to select an area for capture.3 Hold down the SHIFT button and press the RECbutton.• The specified area is automatically registered on thecard.• The EVENT button flashes during operation.• The current point is registered as an IN point if an IN pointhas not been registered.• Recording stops automatically when the OUT point isreached.If an OUT point has not been registered, recordingcontinues until the STOP button is pressed.Audio and video played back from the current location can berecorded to a card.1 Enter the mode that permits control of externaldevices.Hold down the SHIFT button and press the EVENT buttonwhen the THUMBNAIL and PLAY LIST buttons are off.2 Select the start of a section you want to capture.• Use the PLAY, STILL or other buttons to locate the startof the section you want to capture.3 Hold down the SHIFT button and press the RECbutton.• Start playback on the external device to start recording.• To end recording, press the STOP button.◆ NOTE:• The accuracy of recording start varies with the connected externaldevice.Automatic Recording of CardsUsing the RS-422A interfaceIN+ENTRY Registers IN pointsIN+RESET Deletes IN pointsOUT+ENTRY Registers OUT pointsOUT+RESET Deletes OUT pointsIN+GOTO Sends a CUE-UP command to move to anIN pointOUT+GOTO Sends a CUE-UP command to move to anOUT pointIN Checks an IN point (counter indication)OUT Checks an OUT point (counter indication)IN+OUT Checks a DUR (counter indication)Using the IEEE1394 interface
