Panasonic 1M Operation Manuals

Contents

Panasonic 1M Operation Manuals Manual pdf 97 page image

INTRODUCTION USUAL USAGE SETTING ACCORDING TOYOUR PREFERENCESOPERATIONS AND MEASURESWHEN AN ALARM GOES OFF OTHERRECORDMANAGEMENTSECURITY ALARM SETTINGAND DISARMINGYou can set the security alarm when going out and disarm it when you return home.For this reason, the alarm delay time (from the time at which the security alarm is set and till you goout from the dwelling unit door) and the preliminary alarm time (period from the time at which youopen the door till the time you disarm the security alarm) are set to the doors of dwelling units.When going outIt takes approximately 60 seconds (alarm delay time) for the security alarm to turn on aftersetting it on the base unit.Opening the front door within the alarm delay time will not cause the security alarm to sound.* You can shorten the alarm delay time using the Door Phone. ( Page 101)When returning home60 seconds from opening the front door is the "preliminary alarm time". If you disarm the alarmwithin the preliminary alarm time ( page 102), the security alarm will not sound. (The securitypreliminary alarm sounds.)If the security alarm is enabled after locking up the door and windows, the base unit reports when they are openedby an intruder by generating an alarm. When a certain period of time has elapsed, it also notifies the handset of thedoor phone and the manager room of the alarm. You can also disarm the security alarm after it is set.* You can use the external security setting switch to activate/deactivate the alarm. (if it is installed)( pages 104-105)NoteUnlockCallUNLOCKTALKReset/Stop AlarmEmergencyRESET/STOP ALARMEMERG.FIRE CONFIRMMENUOFFFire confirmationEndMenuPowerPOWER97Security AlarmThe factory default settings for the alarm delay time and the preliminary alarm time are as follows:Windows (Security 1, Security 3and Security 4)Front door (Security 2)Alarm delay timeSetting item Securitypreliminary time0 seconds(immediately) 0 seconds(immediately)60 seconds 60 secondsUse the system after confirming that each device is properly installed.NoteLocking the doorLocking thewindowsSetting thesecurity alarm1 2 3The method to activate/deactivate the security alarm depends on the equipment installed in your apartmentbuilding and the equipment settings. Ask the company that installed the system or the administrating company.The security alarm is set to the 4 circuits (windows and door) at the same time. If a window or thedoor is opened after setting the security alarm,the set magnet switch is activated and it transmits asignal to the base unit that triggers an alarm.The operation manual assumes that the above times are set.* The time settings can be changed as shown below.Depending on the installation conditions, users can also change the time settings.(Contact the company that installed the system or the administrating company.)Alarm delay time: 0 (immediately), 60, 120, 300 secondsPreliminary alarm time: 0 (immediately), 60, 120, 300 seconds