Current status(Factory setting: Home)INTRODUCTION USUAL USAGE SETTING ACCORDING TOYOUR PREFERENCES OPERATIONS AND MEASURESWHEN AN ALARM GOES OFF OTHERRECORDMANAGEMENTSECURITY ALARM SETTINGAND DISARMINGChanging Living Mode17Setting Details (Factory Setting)Living Mode Not Home( Page 19)Security *1( Page 20)Ringtone Volume( Page 20)Elevator *2( Page 20)On On High No LinkAbsenceOff Off Off No LinkSleepingOff Off High No LinkHomeTouch in the Top Menu to display the screen below.Selecting the current Living Mode (Absence/Sleeping/Home) will set the base unit statusappropriately according to the mode all at once. Change the Living Mode according to the scenes.Touch the button of a modeon this screen to change tothe corresponding LivingMode.Current Living Mode status(Factory setting: Home)Current Living ModeTo change the settingsof each mode, touch.This operation manual describes functions assuming that this product is used with the factory setLiving Mode.*1 Installation settings are required. (Consult with the company that installed the systemor the administrating company.)*2 Setting with the manager room base unit or the Lobby Phone is required.(Consult with the company that installed the system or the administrating company.)Note If the security setting is set to "ON" in all modes, it cannot be disarmed.If the Security settings or Absence Mode settings are changed for the current LivingMode, the setting for the Living Mode display is cancelled.To change the Living Mode settings, set the Living Mode again.Note Some functions may not be available due to the equipment being used.
