UNLOCKRESET/STOP ALARMEMERG.TALKFIRE CONFIRMMENUOFFPOWER OPENNot Home Alarm LockNOTHOMEGas GAS SETWhen Using Too Much Electricity88NoteNoteAlarm Stop buttonReduce the electricity usage.20Message displaylights in redPress the Alarm Stop button.How to stop the call messageMeasures taken when a call is madeThe message is displayed for about1 minute.12The message lights in red and thepower usage indicator flashes3NoteNothing is displayed if you are using a distribution board without overcurrent alarm device.Use the system after confirming that each device is properly installed.The figure shows an example where ahousehold distribution panel with an overcurrent alarm device (data output)If you are using a distribution panel withoutlevel meter, the message lights up in red.For information on screen display and callmessages, refer to "LCD display and callmessages". ( Page 89)The alarm message "(beep sound)Too much electricity is being used"is output from the speakers of thebase unit and extension speakersNote While the power usage is 110% or more, thescreen display does not turn off.It is also possible to turn off the screen.( Page 75)If the electricity usagebecomes 100% or below (or90% or below), the callmessage automatically stopsThe message stop once but it will be repeateduntil the electricity usage becomes 100% or less(or 90% or less).InstallerSettingTo change the contracted demand, itis necessary to change thedistribution panel setting.Consult with the administratingcompany.The electricityusage indicatorflashes."Be-Be-Beep",Too much electricityis being used.
