Using the System Drives and Bays 5-56. Pull the device out of the system.Note If you release the latch before completely removing the device, the devicecasing catches on the inside of the latch.Removing the deviceInstalling a Device in the NEC VersaBay IIIUse the following steps to install a device in the NEC VersaBay III.Your system must be powered on but not in a sleep state or powered off beforeremoving or inserting devices in the NEC VersaBay III.1. Use the NEC VersaBay III Swap utility or power off the system.2. Close the LCD panel and turn the system upside down.3. Locate the NEC VersaBay III release lock and release latch on the bottom of theunit.4. Slide the lock to the unlocked position, if necessary.5. Slide the latch toward the rear of the system and hold it.6. Align the device in the NEC VersaBay III and push it in until it locks into place.
