5-4 Using the System Drives and BaysSwap devices in the NEC VersaBay III as follows:1. If you have files open on the device you are planning to remove, close them.2. Double click on the swap utility taskbar icon to display the menu.3. A dialog box appears identifying the device in the NEC VersaBay III along with aSwap Device button.4. Click the Swap Device button.5. Click Yes to continue.6. Remove the current device from the NEC VersaBay III and install the new device.References to the drive letter listed under My Computer and the Windows Explorerchange automatically when the device is swapped or removed. The balloon messagethat appears when you move your cursor over the taskbar icon also changes to reflectthe new VersaBay status.Removing a Device from the NEC VersaBay IIIUse the following steps to remove a device from the NEC VersaBay III.Your system must be powered on but not in a sleep state or powered off beforeremoving or inserting devices in the NEC VersaBay III.1. Use the NEC VersaBay III Swap utility or power off the system.2. Close the LCD panel and turn the system upside down.3. Locate the NEC VersaBay III release lock and release latch on the bottom of theunit.4. Slide the lock to the unlocked position before releasing the latch.5. Slide the latch toward the rear of the system and hold it.
