Using the BIOS Setup Utility 3-7System Security SetupUse the System Security Setup to establish system passwords.System Security SetupParameter Default Setting Alternate Setting(s)Assign SupervisorPasswordPress EnterAssign User Password Press EnterBoot Password Required Yes NoResume PasswordRequiredYes NoAssign HDD Password Press EnterInternal HDD Password Disabled EnabledVersaBay HDD Password Disabled Enabled! Assign Supervisor Password — Establishes password protection for entering theBIOS Setup utility, booting the system, and resuming from Standby. (Resume fromStandby, not applicable in Windows 98/2000 with ACPI.)! Assign User Password — Establishes a user password once a supervisor passwordis set.! Boot Password Required — Indicates whether or not a password is required duringsystem boot.! Resume Password Required — Indicates whether or not a password is requiredduring system resume. Boot Password must be defined to activate this parameter.! Assign HDD Password — Allows you to assign a password to allow or restrictaccess to the hard disk drive contents.! Internal HDD Password — Enables or disables the HDD password.! VersaBay HDD password — Enables or disables the VersaBay III password.Establishing System PasswordsTo establish password protection for entering the BIOS Setup utility or accessing thesystem at startup, you must set the supervisor password before setting a user password.! To enter a password simply select Assign Supervisor Password, enter the password,re-enter the password to confirm, and press any key to continue. Repeat theprocedure to set the user password.
