Maintenance Section 414 Part Number 000007646 11/10Cleaning and SanitizingMONTHLY SANITIZING PROCEDURE1. Remove the front panel, paddle wheel, ice chute anddoor assembly.2. Mix a solution of 3 ounces (100 ml) Manitowoccleaner per 1 gallon (4 liters) plain tap water.3. Carefully clean all parts removed from inside the binwith this cleaner. Clean the dispenser bin, doorassembly, and ice chute.4. Rinse all cleaned parts with fresh, running tap water.5. Mix a solution of 3 ounce (90 ml) Manitowocsanitizer with 4 gallons (15 liters) plain tap water.6. Sanitize each part washed in the previous step withthis sanitizer solution. Sanitize and re-assemble inthis order:Paddle wheelAgitatorPaddle wheel pinIce chute assemblyScrap ice trayFront panel7. Do not rinse dispenser parts after they are sanitized.Allow parts to air dry.8. After all dispenser parts are replaced, restore powerto the dispenser.9. Turn the ice machine on.10. Allow the ice machine to begin filling the dispenser.11. After three batches are in the dispenser, test thedispenser operation.AssemblyRE-INSTALLING THE PADDLE WHEEL GUARDWhen re-assembling the rocking chute/door, the paddlewheel guard is installed inside the ice dispense snout.When the paddle wheel guard is placed in the snout, itstop hinge is snapped into mounting holes on both sidesof the snout.When the paddle wheel guard is correctly installed, thepaddle wheel guard will swing outward toward the frontof the chute, allowing ice to flow out of the chute.If incorrectly installed, the paddle wheel guard will notswing outward and ice delivery is blocked.Correct InstallationIf you press your finger forward against the paddle wheelguard, the paddle wheel guard does not swing backopen.! WarningElectric Shock HazardUnplug unit before servicing or cleaning.PaddleWheelGuard