Kidde 10SCO User Manual

Also see for 10SCO: User guide

Contents

Kidde 10SCO User Manual Manual pdf 9 page image

• Permanent independent smoke and carbon monoxide sensors.• Smoke alarm takes precedence when both smoke andcarbon monoxide are present.• Alarm/Voice message warning system that alerts you of thefollowing conditions in the manner described below, thuseliminating any confusion over which alarm is sounding:o FIRE: The alarm/voice pattern is three long alarm beepsfollowed by the verbal warning message “FIRE! FIRE!”.This pattern is repeated until the smoke is eliminated. Thered LED light will flash while in alarm/voice mode.o CARBON MONOXIDE: The alarm/voice pattern is four shortalarm beeps followed by the verbal warning message“WARNING! CARBON MONOXIDE!”. After four minutesthe alarm/voice pattern will sound once every minute untilthe unit is reset, or the CO eliminated. The red LED lightwill flash while in alarm/voice mode.o LOW BATTERY: This alarm has a low battery pre-warning.The red LED will flash every 60 seconds for a period of 28days. Following this pre-warning, when the battery is lowand needs replacing, the red LED will flash and the unitwill "chirp" one time, followed by the warning message"LOW BATTERY". This cycle will occur once every minutefor the first hour. After the first hour the red LED light willcontinue to flash every minute accompanied by the“chirp” only sound. The voice message “LOW BATTERY”will sound once every fifteen minutes during the “chirp”only cycle. This will continue for at least seven days.• Voice Message System that alerts user to the followingconditions:o System announces “HUSH MODE ACTIVATED” when theunit is first put into HUSH Mode.o System announces “HUSH MODE CANCELLED” when unitresumes normal operation after Hush Mode has beencancelled.o System announces “CARBON MONOXIDE PREVIOUSLYDETECTED” when the unit has detected CO concentra-tions of 100 ppm or higher.4Features2540-7205-02_10SCO(KN-COPE-D).qxd:_ 2014.3.21 10:48 AM Page