Kidde 10SCO User Manual

Also see for 10SCO: User guide

Contents

Kidde 10SCO User Manual Manual pdf 15 page image

Step 2: Mounting InstructionsCAUTION: YOUR SMOKE/CO ALARM IS SEALEDAND THE COVER IS NOT REMOVABLE!1. To help identify the date to replace the unit, a label hasbeen affixed to the side of the alarm. Write the “Replaceby” date (10 years from initial power up) in permanentmarker on the label. See Alarm Replacement section foradditional information.2. Remove the mounting bracket from the back of the alarmby holding the mounting bracket and twisting the alarm inthe direction indicated by the “OFF”arrow on the alarmcover.3. Selecting the proper location for your Smoke/CO Alarm, asdescribed on Pages 8-11. To ensure aesthetic alignment ofthe alarm with the hallway, or wall, the “A” line on themounting bracket must be parallel with the hallway whenceiling mounted, or horizontal when wall mounted.4. Install the alarm on the mounting bracket and rotate thealarm in the direction of the “ON” arrow on the coveruntil the alarm ratchets into place (this ratcheting functionB. Where Not to Install:Do not install in garages, furnace rooms or bath-rooms! INSTALL AT LEAST 5 FEET AWAY FROM ANYFUEL BURNING OR COOKING APPLIANCE• Don’t install within 5 feet of fuel burning appliances• Don’t wall-mount close to obstructions (e.g. behind cur-tains, shelving or furniture)• Don’t fit in dusty, dirty or greasy areas (e.g. garages orworkshops)• Don’t wall-mount within 30cm of the ceiling as this is a“dead air” space• Avoid humid areas (such as bathrooms) with greaterthan 90% relative humidity (RH), non-condensing, orareas with temperatures outside of the operating range(0-40C). Keep away from sinks.• Don't install within 1 metre of fluorescent lights10Operating and Installation Instructions!WARNING - This product is intendedfor use in ordinary indoor locations offamily living units.!2540-7205-02_10SCO(KN-COPE-D).qxd:_ 2014.3.21 10:48 AM Page