Kalkhoff Kalkhoff User Manual

Contents

Kalkhoff Kalkhoff User Manual Manual pdf 298 page image

English–90 276 001 Y45 | (12.10.12) Bosch eBike SystemsTechnical DataAssembly Place down the battery pack only on clean surfaces. Inparticular, avoid soiling the charge socket and the con-tacts, e. g. by means of sand or ground.Checking the Battery Pack Before Using for theFirst TimeCheck the battery pack before charging it or using it with youreBike for the first time.For this, press the On/Off button 22 to switch on the batterypack. When no LED of the charge-control indicator 21 lightsup, the battery pack may be damaged.When at least one, but not all LEDs of the charge-control indi-cator 21 is lit, then fully charge the battery pack before usingfor the first time. Do not charge a damaged battery pack and do not useit. Please refer to an authorised bicycle dealer.Charging the Battery Pack Use only the charger provided with your eBike or anidentical original Bosch charger. Only this charger ismatched to the lithium-ion battery pack used in your eBike.Note: The battery pack is supplied partially charged. To en-sure full battery pack capacity, completely charge the batterypack in the charger before using for the first time.The battery pack must be removed from the eBike for charg-ing.For charging the battery pack, read and observe the operatinginstructions of the charger.The battery pack can be charged any time without reducingthe service life. Interrupting the charging procedure does notcause damage to the battery pack.The battery pack is equipped with a temperature control indi-cator, which enables charging only within a temperaturerange between 0 °C and 40 °C.When the battery pack is notwithin the charging-tempera-ture range, three LEDs of thecharge-control indicator 21flash. Disconnect the battery pack from the charger until itstemperature has adjusted.Do not connect the battery pack to the charger until it hasreach the allowable charging temperature.Charge-control IndicatorWhen the battery pack is switched on, the five green LEDs ofthe charge-control indicator 21 indicate the charge conditionof the battery pack.In this, each LED indicates approx. 20 % capacity. When thebattery pack is completely charged, all five LEDs light up.Additionally, the charge condition of the switched on batterypack is indicated on the drive HMI. Read and observe the op-erating instructions of the drive unit and the drive HMI.When the capacity of the battery pack is below 5 %, all LEDsof charge-control indicator 21 on the battery pack go out;however, the drive HMI does provide an additional indicationfunction.Inserting and Removing the Battery Pack(see figures C–D) Always switch the battery pack off when inserting orremoving it from the holder.In order for the battery pack to be inserted, the key 23 mustbe inserted into the lock 24 and the lock must be unlocked.To insert the standard battery pack 26, place it via the con-tacts onto the bottom holder 27 on the eBike. Pivot the bat-tery pack to the stop into the upper holder 25.Lithium ion battery pack PowerPack 300 PowerPack 400Article number– Standard battery pack, black– Standard battery pack, white– Rack-type battery pack0 275 007 5000 275 007 5010 275 007 5020 275 007 5030 275 007 5040 275 007 505Rated voltage V= 36 36Rated capacity Ah 8.2 11Energy Wh 300 400Operating temperature °C –10...+40 –10...+40Storage temperature °C –10...+60 –10...+60Allowable charging temperature range °C 0...+40 0...+40Weight, approx. kg 2.5 2.5Degree of protection IP 54 (dust and splash waterprotected)IP 54 (dust and splash waterprotected)