Husqvarna DXR 95 Operator's Manual

Also see for DXR 145: Operator's manual

6. Loosen the 5 bolts (D) and remove the rear cover (E)on the product.DDED7. Start the product. Refer toTo start the product (DXR95) on page 70.8. Put a magnet on the bottom side of the radiocommunication receiver on the magnet symbol (F)in 5 s after the start of the product. The indicator (G)on the radio communication receiver flashes orangequickly when it waits for a pairing operation to start.F GNote: It is necessary to put the magnet on themagnet symbol in 5s after the start of the product.After 5s the radio communication receiver cannot dothe pairing operation.9. Remove the magnet immediately.10. A serial number shows on the information centerdisplay when a radio communication receiver isfound.11. Make sure that the serial number on the informationdisplay agrees with the serial number on the radiocommunicator receiver.12. If the serial numbers do not agree, the pairingoperation was not done correctly. Do the procedurethat follows.a) Find the product with the agreed serial numberand turn that product off.b) Stop your product. Refer toTo stop the product(DXR 95) on page 83.c) Do the pairing operation again.13. Push the right side button when the serial numbersagree. A message on the information center displaywill show for 2 seconds that the pairing operation isdone.14. Stop the product to restart the radio communicationreceiver. Refer toTo stop the product (DXR 95) onpage 83.15. Restart the remote control. Refer toTo start theremote control on page 73.16. Start the product. Refer toTo start the product (DXR95) on page 70.17. Make sure that there is a radio signal symbol inthe information center display. Refer toInformationcenter display on page 68.18. Install the rear cover on the product.To do a pairing operation between theremote control and the product (DXR145)The pairing operation between the product and theremote control is done by the factory. A new pairingoperation is necessary if the remote control is replacedor if you change remote controls between products.1. Start the remote control. Refer toTo start the remotecontrol on page 73.76 1401 - 005 - 11.01.2024