Husqvarna DXR 95 Operator's Manual

Also see for DXR 145: Operator's manual

Radio signal SymbolNo radio signal.• Battery status (B). The same symbols are alsoshown in the top bar on the display. Refer toSymbols in the top bar on the display on page 18.State of charge SymbolThere are 5 levels of charge for thebattery.Battery fault./Cable connection between the re-mote control and the product.There are 2 buttons for the information center display.The left side button (C) moves to the next symbol in thedisplay. The right button (D) makes the selection.Remote control batteriesWARNING: Before you use the remotecontrol batteries and the charger, you mustread and understandBattery safety on page27 andBattery charger safety on page 27.Note: It is necessary to charge the batteries beforeyou use the remote control for the first time.Note: Put the battery in the charger for approximately10 seconds to start the battery if it is in sleep mode.The remote control has 2 battery slots. Each batteryhas a state of charge symbol on the display and theinformation center display, refer toSymbols in the topbar on the display on page 18 andInformation centerdisplay on page 68. It is not possible to operate theremote control if the state of charge of the remotecontrol batteries is too low.The operation time for fully charged remote controlbatteries is approximately 12 hours. Cold weather candecrease the operation time. If the display is usedfrequently, the operation time can decrease.If you do not use the batteries for 5 days, the batteriesgo into shipping mode. The shipping mode saves energyand the remote control cannot start to operate. Whenthe batteries are in shipping mode, you must connectthem to the charger for 10 seconds to exit shippingmode.Charge the remote control batteries each 6 months tokeep the quality of the batteries.To remove and install the remote controlbatteries in the remote controlNote: It is necessary to charge the batteries beforeyou use the remote control for the first time.Note: Put the battery in the charger for approximately10 seconds to start the battery if it is in shipping mode.1. Turn the remote control to get access to the rearside where the batteries are.2. Remove or install the remote control batteries.WARNING: Make sure that youinstall the batteries with the poles inthe correct direction. There is a risk ofelectrical shock.To charge the remote control batteries with thebattery chargerThe charging time for an empty remote control batteryis approximately 3 hours with the battery charger. Whenyou charge the remote control batteries, the temperaturemust be between 10°C/50°F and 45°C/113°F.1. Remove the empty remote control battery from theremote control. Refer toTo remove and install theremote control batteries in the remote control onpage 69.1401 - 005 - 11.01.2024 69