Husqvarna DXR 95 Operator's Manual

Also see for DXR 145: Operator's manual

3. Disconnect the exit hose.4. Remove the pump element (C).C5. Make sure that grease comes out of the hole forthe exit hose (E). Make sure that there are no airbubbles in the grease that comes out of the hole forthe exit hose.E6. Install the pump element.7. Go to the "Functions" menu in the remote control.8. Select "Fill grease hose".9. Make sure that grease comes from the pumpelement.10. Connect the exit hose.To fill the grease hose (DXR 95)If you replace the grease hose, it is necessary to fill thenew grease hose with grease.1. Go to the "Functions" menu in the remote control.ToolsControlsSystemMachine statusFunctionsOil refillFill grease hose2. Select "Fill grease hose".3. Use the + (A) and - (B) buttons to enter the length ofthe grease hose.ToolsControlsSystemMachine statusFunctions 25HOSE LENGTHSET HOSE LENGTH. PRESS TO STARTDEFAULT: 25(25-200) cm ACB4. Press the button (C) to fill the grease hose. Theproduct stops when the grease hose is full.1401 - 005 - 11.01.2024 109