Honeywell Tuxedo Touch WIFI Installation And Setup Manual

Also see for Tuxedo Touch Wi-Fi: User guide Quick installation guide

Honeywell Tuxedo Touch WIFI Installation And Setup Manual Manual pdf 44 page image

44Important NotesFor additional troubleshooting procedures, refer to the Control Panel Installation Guide.General Notes• You may check to see whether the Chime Mode is ON or OFF by viewing the keypad OperatingModes screen as described in “Operating Modes” in Section 5 of the keypad Installation and SetupGuide.• Note that some displays on the keypad may not have enough space to display the whole name of apartition. When this occurs, the display shows as many characters as possible starting at thebeginning of the partition name. We recommend that the partition name be kept to a maximum of7 characters to ensure the “H” which indicates the home partition may be seen.• “Exit Error” and “Auto Arm Alert, Please Leave Now” messages are not displayed by the keypad.• When the system has 6150Vs or 6160Vs, and 6271Vs attached, the Additional Console setting inthe 6150Vs (displayed as A on the 6150V) must be set to 1 and the Additional Console setting inthe 6160Vs must be set to Yes.Commercial System Notes• If the Aux Relay function is set for alarm silenced by User Code + # + 67, this command may onlybe entered in the console emulation mode.• Do not use the common lobby logic function.• If fields 2*22 (Display Fire Alarms of other Partitions), 2*23 (Display Burg & Panic of otherPartitions), or 2*24 (Display Troubles of other Partitions) are enabled, the zones that created theconditions cannot be viewed. You must go to that zone's home partition to view.• If field 1*11 (Zone Bypass After Disarm) is enabled, you must use the keypad’s Console EmulationMode and the commands “Code” + “64” (unbypass all) or “Code” + “6” + “Zone Number” (unbypasszone) to remove zone bypasses.• The First to Alarm Display Lock feature (field 1*10) is not supported by the keypad.• RF Low Battery messages are not supported by the keypad except in the Show Zones screen wherea Battery Icon is displayed for the zone with the low battery.Residential System Notes• If the Clean Me option is set, when the maintenance signal is received a “Fire Maintenance”message and the Display Faults icon is shown. However, if you display the faults, zone 1 is notshown as a faulted zone.• If RF Jam Reports are selected and RF Jam is detected, the User Authorization screen displays“Trouble ZN100 RF Receiver”. If you enter the console emulation mode, the display shows “Check90 RF Receiver Jam”.• Do not use the Custom Word reminder feature.User Related Notes• Users added to the system using the keypad graphic user screen must be deleted from the keypadusing the graphic screen as well. Deleting users from the panel by any other means (alpha keypad,console emulation mode, or Compass downloader) does not automatically delete them from thekeypad.