Honeywell Tuxedo Touch WIFI Installation And Setup Manual

Also see for Tuxedo Touch Wi-Fi: User guide Quick installation guide

Honeywell Tuxedo Touch WIFI Installation And Setup Manual Manual pdf 36 page image

Automation (cont’d)36Remove a Honeywell ThermostatTo remove a Honeywell Thermostat from the Z-Wave network, do the following:ICON ACTION NOTES1. At the Tuxedo Touch Keypad:a) Press the Automation icon from the“Home” screen and then press theZ-Wave Setup icon to display the“Z-Wave Device Management” screen.b) Highlight the thermostat and press theZ-Wave Remove/Delete icon.Note: Honeywell is not responsible for propertydamages due to improper setting of the thermostatmodes.Z-Wave Remove/Delete -clears the node fromthe keypad and resets device to the defaultsetting.2. At the thermostat:a) Follow the instructions in thethermostat Installation Guide under“Installer setup” to “Remove a Z-WaveNetwork Connection”.b) Once the exclusion process is complete,press Done and the thermostat isremoved.Notes:• If the device is not removed, refer to the“Z-Wave Troubleshooting” section.• To remove a defective device, refer to the“Z-Wave Troubleshooting” section.Remove All Z-Wave DevicesICON ACTION NOTES1. At the Tuxedo Touch Keypad:a) Press the Automation icon from the“Home” screen and then press theZ-Wave Setup icon to display the “Z-Wave Device Management” screen.b) Press the Z-Wave Reset icon to deleteall devices from the controller.c) Select Yes or No.The message is displayed:Window WarningThis Z-WAVE controller is about to be factorydefaulted and will lose all devices in the enrolledlist. All Z-WAVE devices must be re-enrolledafter this reset.Yes or NoAbort a Z-Wave ActionICON ACTION NOTES1. At the Tuxedo Touch Keypad:a) Press the Automation icon from the“Home” screen and then press the Z-Wave Setup icon to display the “Z-WaveDevice Management” screen.b) Press the Z-Wave Abort Operation iconto abort that process.If inadvertently a wrong process is selected, (i.e.,add, delete, or remove failed device) press theZ-Wave Abort icon to abort that process.