Honeywell Tuxedo Touch WIFI Installation And Setup Manual

Also see for Tuxedo Touch Wi-Fi: User guide Quick installation guide

Honeywell Tuxedo Touch WIFI Installation And Setup Manual Manual pdf 35 page image

Automation (cont’d)35Editing Z-Wave Device NamesEdit a Device Module NameTo edit a device name, do the following:Remove/Delete Z-Wave DevicesRemove a Light, Outlet, or Switch ModuleTo remove a device from the Z-Wave network, do the following:ICON ACTION NOTES1. At the Tuxedo Touch Keypad:a) Press the Automation icon from the“Home” screen and then press theZ-Wave Setup icon to display the“Z-Wave Device Management” screen.b) Highlight the device to remove and pressthe Z-Wave Remove/Delete icon.2. At the device module:a) Press the Function Key to remove thedevice from the keypad.Z-Wave Remove/Delete -clears the node fromthe keypad and resets device to the defaultsetting.Notes:• If the device is not removed, refer to the“Z-Wave Troubleshooting” section.• To remove a defective device, refer to the“Z-Wave Troubleshooting” section.Remove a Door Lock DeviceTo remove a door lock module from the Z-Wave network, do the following:ICON ACTION NOTES1. At the Tuxedo Touch Keypad:a) Press the Automation icon and thenpress the Z-Wave Setup icon to displaythe “Z-Wave Device Management” screen.Z-Wave Remove/Delete-clears the node fromthe keypad and resets device to the defaultsetting.Notes:• If the device is not removed, refer to the“Z-Wave Troubleshooting” section.• When removing the door lock, the user codeassociated with the door lock will remain in thesystem. If needed refer to the panel InstallationInstructions on how to remove this user code.• To remove a defective device, refer to the“Z-Wave Troubleshooting” section.b) Highlight the device to remove and pressthe Z-Wave Remove/Delete icon.2. At the door lock:a) Press the Function Key to remove thedevice from the keypad.ICON ACTION NOTES1. At the Tuxedo Touch Keypad:a) Press the Automation icon from the“Home” screen and press the Z-WaveSetup icon to display the “Z-Wave DeviceManagement” screen.b) Highlight the device name and press theZ-Wave Edit icon.c) On the “Data Entry” keyboard, pressClear and enter a new name; press GO.Enter the new device name by entering it on thedata entry keyboard.• Press the Up Arrow key to switch to capitalletters• Press the X key to delete• Press the ABC/.?123 key to switch betweennumerals and symbols/characters.• Press GO to return to the previous screen.