Honeywell Tuxedo Touch WIFI Installation And Setup Manual

Also see for Tuxedo Touch Wi-Fi: User guide Quick installation guide

Honeywell Tuxedo Touch WIFI Installation And Setup Manual Manual pdf 31 page image

User System Setup (cont’d)31ICON ACTION NOTES(Primary) state, press the Z-Wave PrimaryController Shift to Secondary icon.5. To shift the primary controller role to ahandheld controller, follow the handheldcontroller manufacturer’s instructions.When the pop-up message disappears andcontrollers have shifted successfully, Z-Wavedevices can be enrolled from this controller.6. Shift the Tuxedo Touch back to the primarycontroller after enrolling Z-wave devices.First, initiate the role shift on the handheldcontroller from primary to secondaryreferring to manufacturer’s instructions.Then, press the Z-Wave SecondaryController Shift to Primary icon on thekeypad.Select from two main categories of tests:• Z-Wave Role Shifting: Primary to Secondaryand Secondary to Primary.• Z-Wave Basic Command: Set On or Off.A pop-up window is displayed with the following:“Role Shift is in progress, please wait ...This Z-Wave controller shift function is forevaluation only now. This primary controlleris shifting to the secondary.The Shift is completed when the pop-up windowdisappears.Note: The Z-Wave Primary Controller Shift toSecondary icon is inactive when the TuxedoTouch keypad becomes the secondarycontroller.7. Select the Z-Wave Basic Command Set Onicon to turn On all lamp modules, dimmerOn/Off switches and receptacles.Note: This command does not control door locksor any other security enabled devices.Note: This test may cause lights and thermostatsettings to change."8. Select the Z-Wave Basic Command Set Officon to turn Off all lamp modules, dimmerOn/Off switches and receptacles.Note: This test may cause lights and thermostatsettings to change."NIGHT Setup FunctionThe NIGHT function can be set to arm the system in one of five arming modes:• Away - Arms all zones with entry delay.• Stay - Arms perimeter zones with entry delay.• Instant - Arms perimeter zones without entry delay.• Night (Residential Panels Only) – Arms all perimeter zones plus all zones listed in Zone List 5.• Maximum - Arms all zones without entry delay. Not to be used for ANSI/SIA CP-01 installations.To set the NIGHT function, do the following:ICON ACTION NOTES1. Press the System Setup and AdvancedSetup icon.2. Enter your Authorized Code, if required.3. Press the Night Setup icon.4. Select the arming mode to be activatedwhen NIGHT is selected on the "Arming"screen.Apply accepts the setting.Back cancels your selection.Output Setup FunctionThe Output Setup screen displays Output selections. There are a maximum of 18 outputs that can beenabled or disabled. To set the Output Setup function, do the following: