Honeywell Tuxedo Touch WIFI Installation And Setup Manual

Also see for Tuxedo Touch Wi-Fi: User guide Quick installation guide

Honeywell Tuxedo Touch WIFI Installation And Setup Manual Manual pdf 39 page image

Automation (cont’d)39Notes:1. Motorized door lock bolts physically lock and unlock when activated, but if the door lock installed is anon-motorized type, activation allows the door to be manually unlocked without a key. See“Compatible Devices” section for further information.2. Some thermostats do not update temperature status automatically (i.e., Wayne Dalton).3. When using a Kwikset Smartcode electronic deadbolt door lock (in a Scene that is programmed totrigger when unlocked) the Scene does not trigger if using a key; enter a user code.Create a GroupMultiple Z-wave devices can function together in a group. Up to 50 groups can be created. Follow theprocedure below to create a Group.ICON ACTION NOTES1. Press the Automation icon and thenpress the Group Setup icon.2. Press the Add icon and enter a “GroupName” on the “Data Entry” keyboard.3. Press GO.4. Highlight the device(s) from the list thatyou want to add to this Group and pressthe Save icon.Group names (i.e., All, etc.) are displayed across thetop to the screen.Use the Data Entry Keyboard to enter all requiredinformation.• Press the Up Arrow key to switch to upper caseletters• Press the X key to delete• Press the ABC/.?123 key to switch betweennumerals and symbols/characters.• Press GO to return to the previous screen.Group Setup IconsDelete Edit Add SaveIf settings were changed, a pop-up window displays:Settings saved. Select OK to save.Setting a Secondary Keypad (Controller)After all Z-Wave devices have been enrolled into the Primary Keypad (Controller), the deviceinformation on the Primary Controller can be downloaded to a Secondary Keypad (Controller). Keep thecontrollers within 10 feet of each other, apply power to the Secondary Controller and do the following:ICON ACTION NOTES1. On the Primary Controller:a) Press the Automation icon from the“Home” screen and then press the Z-Wave Setup icon to display the “Z-WaveDevice Management” screen.If used for Remote Services, Tuxedo WiFi should notbe configured as a secondary controller. See theRemote Services section.2. At the Secondary Controller:a) Remove any Z-Wave devices that havebeen added.b) Press the Z-Wave Primary icon(located in the lower right side of thescreen).c) Select Yes to change this keypad to aSecondary Controller.When the Primary Controller icon is pressed, themessage is displayed:“Please remove all Z-wave devices from networkfirst”The message is displayed: “Scanning for Devices”The message is displayed: “Updating Devices.Please Wait”