CHAPTER 5: Using the BIOS Setup Utility www.gateway.com683 Remove the jumper across pins 1-2 of header J3-E, then place the jumperacross pins 2-3.4 Follow the instructions in “Closing the server case” on page 32.5 Insert a bootable USB “disk-on-key” containing a valid BIOS image into aUSB port.6 Reconnect the power cords and turn on the server. The BIOS recovery isinitiated.7 While the BIOS is being recovered, the monitor displays a blue screen andthe server will beep continually. The process is complete when the serverstops beeping.8 Remove the bootable USB “disk-on-key.”9 Turn off the server, then disconnect the power cords and all other cablesconnected to the server.10 Follow the instructions in “Opening the server case” on page 31.11 Place the jumper back onto pins 1-2.12 Follow the instructions in “Closing the server case” on page 32.13 Plug in the AC power cords and turn on the server, then verify that therecovery was successful.Resetting the BIOSYou can use two methods to clear all BIOS Setup settings and return them tothe factory defaults:■ Press the power and reset buttons on the front of the server.■ Move the Clear CMOS jumper on the system board.
