Gateway E-9525R User Manual

Also see for E-9525R: User guide

Contents

Gateway E-9525R User Manual Manual pdf 121 page image

www.gateway.com115Regulatory compliance statementsUnited States of AmericaFederal Communications Commission (FCC)Unintentional emitter per FCC Part 15FCC Part 15 Class A StatementThe server is designated as complying with Class A requirements if it bares the following text on the rating label:This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference.(2) This device must accept any interference received, including interference that may cause undesired operation.This device has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limitsare designed to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses,and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interferencewith radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case you willbe required to correct the interference at your own expense.CautionChanges or modifications not expresslyapproved by Gateway could void the FCCcompliance and negate your authority tooperate the product. Telecommunications per FCC part 68(applicable to products fitted with USA modems)Your modem complies with Part 68 of the Federal Communications Commission (FCC) rules. On the computer or modem card is a label thatcontains the FCC registration number and Ringer Equivalence Number (REN) for this device. If requested, this information must be providedto the telephone company.An FCC-compliant telephone line cord with a modular plug is required for use with this device. The modem is designed to be connected tothe telephone network or premises wiring using a compatible modular jack which is Part 68-compliant. See installation instructions fordetails.The Ringer Equivalence Number (REN) is used to determine the number of devices which may be connected to the telephone line. ExcessiveRENs on a telephone line may result in the devices not ringing in response to an incoming call. In most areas, the sum of RENs should notexceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the localtelephone company.If this device causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance ofservice may be required. The telephone company may request that you disconnect the equipment until the problem is resolved.The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of thisequipment. If this happens, the telephone company will provide advance notice in order for you to make necessary modifications tomaintain uninterrupted service.This equipment cannot be used on telephone company-provided coin service. Connection to party line service is subject to state tariffs.Contact the state public utility commission or public service commission for information.When programming or making test calls to emergency numbers:■ Remain on the line and briefly explain to the dispatcher the reason for the call.■ Perform such activities in the off-peak hours such as early morning or late evenings.The United States Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic deviceto send any message via a telephone fax machine unless such message clearly contains, in a margin at the top or bottom of eachtransmitted page or on the first page of the transmission, the date and time it is sent, an identification of the business, other entity, or otherindividual sending the message, and the telephone number of the sending machine or such business, other entity, or individual. Refer toyour fax communication software documentation for details on how to comply with the fax-branding requirement.