Installing and removing driveswww.gateway.com3511 Align the optical drive with the two clips on the left side of the optical drivetray, then press the optical drive into place in the tray.12 Insert the optical drive tray into the bay in the media cage until it clicksinto place.13 Insert the media cage into the assembly bay in the chassis.14 Secure the assembly by tightening the thumbscrew you previouslyloosened.15 Attach the 44-pin optical drive cable to the back of the optical driveinterface board.16 Reinstall the large fan cage by following the instructions in “Replacingsystem fans” on page 46.17 Follow the instructions in “Closing the server case” on page 32.18 Reinstall the bezel, if required, by snapping it into place on the front ofthe chassis.19 Reconnect all power cords and peripheral device cables, then turn on theserver.Removing and installing a tape driveTo remove and install a tape drive:CautionThe tape drive is not hot-swappable.Before installing or removing the drive,make sure that power is turned off andthe power cord(s) is unplugged.1 Follow the instructions in “Preventing static electricity discharge” onpage 30. Make sure that you turn off the server, then unplug the powercord(s) and all other cables connected to the server.2 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.3 Follow the instructions in “Opening the server case” on page 31.4 Remove the large fan cage by following the instructions in “Replacingsystem fans” on page 46.5 Disconnect the data and power cables from the tape drive.6 Loosen the thumbscrew (1) holding the media cage in the chassis, thenpush the assembly (2) out the front of the chassis.
