GE JKP3027 Owner's Manual

Also see for JTP70: Installation instructions Installation instructions Brochure Installation instructions Owner's manual

GE JKP3027 Owner's Manual Manual pdf 28 page image

Problem Possible Causes What To Do“F— and a number You have a function • Press the Clear/Off pad. Allow the oven to cool foror letter” flash error code. one hour. Put the oven back into operation.in the display If the function • Disconnect all power to the oven for at least 30code repeats. seconds and then reconnect power. If the functionerror code repeats, call for service.Display goes blank A fuse in your home may • Replace the fuse or reset the circuit breaker.be blown or the circuitbreaker tripped.The clock is in the • See the Special features of your oven control section.black-out mode.Display flashes Power failure. • Reset the clock.Unable to get the Oven control pads were • The Bake and Broil Hi/Lo pads must be presseddisplay to show “SF” not pressed properly. at the same time and held for 3 seconds.Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must resetclock flashes it by pressing the Clear/Off pad, setting the clockand resetting any cooking function.“Burning” or “oily” This is normal in a • To speed the process, set a self-clean cycle for aodor emitting from new oven and will minimum of 3 hours. See the Using the self-cleaningthe vent disappear in time. oven section.Strong odor An odor from the insulation • This is temporary.around the inside of theoven is normal for the firstfew times the oven is used.Fan noise A cooling fan may • This is normal. The cooling fan will turn onautomatically turn on. to cool internal parts. It may run for up to 1-1/2hours in 30″ models and up to 2 hours in 27″ modelsafter the oven is turned off.28Before you call for service…Troubleshooting TipsSafety InstructionsOperating InstructionsCare and CleaningTroubleshooting TipsConsumer Support