GE Multilin G60 Generator Protection System 6-296 ACTUAL VALUES 6.4 RECORDS6A trigger can be forced here at any time by setting “Yes” to the FORCE TRIGGER? command. Refer to the COMMANDS CLEAR RECORDS menu for information on clearing the oscillography records.6.4.4 DATA LOGGERPATH: ACTUAL VALUES RECORDS DATA LOGGERThe OLDEST SAMPLE TIME represents the time at which the oldest available samples were taken. It will be static until the loggets full, at which time it will start counting at the defined sampling rate. The NEWEST SAMPLE TIME represents the time themost recent samples were taken. It counts up at the defined sampling rate. If the data logger channels are defined, thenboth values are static.Refer to the COMMANDS CLEAR RECORDS menu for clearing data logger records.6.4.5 PHASOR MEASUREMENT UNIT RECORDSPATH: ACTUAL VALUES RECORDS PMU RECORDSThe number of triggers applicable to the phasor measurement unit recorder is indicated by the NUMBER OF TRIGGERS value.The status of the phasor measurement unit recorder is indicated as follows:PATH: ACTUAL VALUES RECORDS PMU RECORDS PMU 1 RECORDING DATA LOGGEROLDEST SAMPLE TIME:2000/01/14 13:45:51MESSAGE NEWEST SAMPLE TIME:2000/01/14 15:21:19 PMU RECORDSNUMBER OF TRIGGERS:0Range: 0 to 65535 in steps of 1MESSAGE PMU 1 RECORDING See below. PMU 1 RECORDINGPMU 1 FORCE TRIGGER:YesRange: No, YesMESSAGE PUM 1 AVAILABLERECORDS: 0Range: 0 to 65535 in steps of 1MESSAGE PUM 1 SECONDSPER RECORD: 0.0Range: 0 to 6553.5 in steps of 0.1MESSAGE PUM 1 LAST CLEARED:2005/07/14 15:40:16Range: date and time in format shown
