Epson Artisan 810 Service Manual

Also see for Artisan 710 Series: Start here Network installation guide Specifications Quick guide Start here

Contents

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision GArtisan 837/730/PX830FWD/PX730WD/TX730WD Disassembly/assembly 312Confidential7. Remove the screws (x2) that secure the Left Hinge.Figure 9-49. Removing the Panel Unit (2)8. Lift the Panel Unit and pull out the Panel FFC from the Panel Unit, and thenremove the Panel Unit.Figure 9-50. Removing the Panel Unit (3)9. Insert the tweezers or the like into section A and peel off the Panel Sheet.Figure 9-51. Removing the Panel Unit (4)Panel UnitC.B.P. 3x10 (6±1Kgfcm)DowelLeft HingeUpper HousingC.B.P. 3x10 (6±1Kgfcm)Panel UnitPanel FFC When installing the Panel Unit, align the dowels (x2) of theUpper Housing with the positioning holes (x2) of the Left Hinge.(See Fig. 9-49 (p.312).) Taking the bottom left corner of the Panel Sheet as thereference point, align the bottom edge with the bottom rib of thePanel Unit and put the left edge against the rib, then attach thePanel Sheet. (See Fig. 9-51 (p.312).) Secure the Panel FFC and ferrite core to the Panel Shield Platewith double-sided tape. (See Fig. 9-43 (p.310).) Fold the Panel FFC at the fold line, and route it through themarking on the Panel Shield Plate. (See Fig. 9-47 (p.311).)Panel SheetPanel UnitSection AReference pointfor the panelsheet attachment