Epson Artisan 810 Service Manual

Also see for Artisan 710 Series: Start here Network installation guide Specifications Quick guide Start here

Contents

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision GArtisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD Adjustment 278Confidential8.4.3 Special Inspection ModeThe capacitive touch panel is employed for Artisan 725/PX720WD/TX720WD,therefore, the start-up method in the special inspection mode differs from that for theothers.If an inspection for Artisan 725/PX720WD/TX720WD in the special inspection modeis necessary, start the printer following the procedure below and then carry out theinspection. The start-up method in the special inspection mode for Artisan 725/PX720WD/TX720WD1. Press the Power button to turn on Artisan 725/PX720WD/TX720WD.2. After the printer turns on normally, turn the power off once.3. Within 30 seconds after turning the power off and the LCD screen goes off,press and keep pressing the sections shown below (1), then press the Powerbutton for more than one second (2) to start Artisan 725/PX720WD/TX720WD in the special inspection mode.Figure 8-29. Starting the Special Inspection Mode(Artisan 725/PX720WD/TX720WD)4. When turning the printer on in the special inspection mode, the followingscreen appears on the LCD. Take the necessary inspection.Figure 8-30. Start-up Screen in the Special Inspection Mode(Artisan 725/PX720WD/TX720WD)CHECKPOINT The start-up method in the special inspection mode for Artisan835/PX820FWD/TX820FWD is the same as Artisan 810/PX810FW/TX810FW. The inspections necessary to start the printer in the specialinspection mode are as follows.• Case open sensor check (p220)• Touch panel operation check (p279) When starting Artisan 725/PX720WD/TX720WD in the specialinspection mode, take the necessary procedure within 30seconds after turning the power off. If 30 seconds or more passafter turning the power off, turn it on once again, then turn itback off and take the necessary procedure within 30 seconds tostart the printer in the special inspection mode. Press the Power button to exit from the special inspection mode.The following screen appears when the Power button is pressed,and the power turns off if the button is kept pressed again.Figure 8-28. Power Off Screen in the Special Inspection Mode If one of the modes in the menu (Fig. 8-30) is selected andentered by pressing the OK button, you cannot go back to thescreen (Fig. 8-30) again. To return to the screen (Fig. 8-30), turnthe power off once, and start the printer in the special inspectionmode once again.Initial Charge Flag checkInitial Charge Flag: OFFInspection Mode Flag checkInspection Mode Flag: OFFPush [Power] button(1) Keep pressing these(2) Press this for more than one sec.Inspection ModeRun: OK / Select: [UP] [DOWN]1. Mechanism Inspection2. Special Inspection3. Development Mode4. Normal Mode