Epson Artisan 810 Service Manual

Also see for Artisan 710 Series: Start here Network installation guide Specifications Quick guide Start here

Contents

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision GDISASSEMBLY/ASSEMBLY Routing FFC/cables 201ConfidentialSTACKING THE HEAD FFC(ARTISAN 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD)Secure the Head FFCs (x4) and the CR Encoder FFC with double-sided tape, stackthem up in numeric order from inside shown in Figure 4-204, and route them.Note * : See Fig. 4-196 for the connector positions on the Main Board.Figure 4-204. Stacking the Head FFC(Artisan 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD)STACKING THE HEAD FFC(ARTISAN 710/725/730/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD)Secure the Panel FFC, the Head FFCs (x4) and the CR Encoder FFC with double-sidedtape, stack them up in numeric order from inside shown in Figure 4-204 and Figure4-205, and route them.Note * : See Fig. 4-198 for the connector positions on the Main Board.Figure 4-205. Stacking the Head FFC(Artisan 710/725/730/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD)No. FFC/cable name CN No.* Remarks1 CR Encoder FFC CN6 Ferrite core (x1)(See Fig. 4-44)2 Head FFC (x4) CN1,2,3,4 ---Sheet SliderSheet SliderTube Guide OuterTube Guide SubTube Guide InnerAttach the Sheet Slider to theHead FFC where the Ink Tubetouches the FFC.Attach Clamp Tubes (x2) to the TubeGuide Outer with double-sided tape.Confirm that the CR Encoder isattached to the Carriage Unit withdouble-sided tape (x4).Double-sided tape123456CR Encoder FFCClamp Tube90 mm110 mmHead FFCHead FFCNo. FFC/cable name CN No.* Remarks1 Panel FFC CN33 Ferrite core (x1)(See Fig. 4-203)2 CR Encoder FFC CN6 ---3 Head FFC (x4) CN1,2,3,4 ---Panel FFCSee Fig. 4-204 forstacking the HeadFFCs (x4) and CREncoder FFC.Secure this sectionto the Head FFC.Secure this section to the Panel Unitand Front Frame. (See Fig. 4-166.)Double-sided tape