Roll printing is selected, but sheets are loaded.Cause Corrective ActionA print job for rolls was re-ceived when a sheet is loaded.Follow these steps to load and print on a roll.1. Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove thesheet.(See "Removing Sheets.") →P.6092. Load a new roll.(See "Loading Rolls in the Printer.") →P.579The printer now starts printing the print job.Press ▲ or ▼ to select Stop Printing, and then press the OK button.The roll is empty.Cause Corrective ActionThe roll is empty. Follow these steps to replace the used roll with a new roll of the same type and size.1. Press the Release Lever back and remove the roll.(See "Removing the Roll from the Printer.") →P.585(See "Removing the Roll Holder from Rolls.") →P.5892. Load the new roll.(See "Attaching the Roll Holder to Rolls.") →P.575(See "Loading Rolls in the Printer.") →P.5793. If no barcode was printed on the roll, specify the type of paper.(See "Changing the Type of Paper.") →P.5834. When you have selected ManageRemainRoll > On in the control panel menu and a barcodeis not printed on the roll, also specify the paper length.(See "Specifying the Paper Length.") →P.5855. If "Not finished printing. Finish printing remaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from the page on which the error occurred.If no message appears, printing will continue from the next page.There is remainingroll paper, but be-cause it could notbe advanced, itcould not be detec-ted.The unused portion of the roll is heavy, and this is placing a burden on the printer. It may behelpful to change the printing mode, which will change the paper feed timing.Choose a higher level of Print Quality in the Advanced Settings of the printer driver.(See "Giving Priority to Particular Graphic Elements and Colors for Printing.") →P.60Error Message > Messages regarding paper >Roll printing is selected, but sheets are loaded. iPF75012816
