The edges of the paper are dirtyCause Corrective ActionThe Platen has become dirty afterborderless printing or printing onsmall paper.Open the Top Cover and clean the Platen.(See "Cleaning Inside the Top Cover.") →P.756The type of paper as specified onthe printer does not match the typespecified in the printer driver.Make sure the same type of paper is specified on the printer as in the printerdriver.(See "Changing the Type of Paper.") →P.583Make sure the same paper type is specified in the printer driver as on the print-er.1. Press the Stop button and stop printing.2. Change the type of paper in the printer driver and try printing again.The paper is wrinkled or warped. Straighten out the wrinkles or curls and reload the paper. Do not use paper thathas been printed on previously.(See "Loading Rolls in the Printer.") →P.579(See "Loading Sheets in the Printer.") →P.602A cut line is printed because Cut-DustReduct. is On in the ControlPanel menu to reduce cutting dust.If this function is not needed, set CutDustReduct. to Off in the Control Panelmenu.(See "Menu Settings.") →P.673The Printhead is set too low in theControl Panel menu.In the Control Panel menu, set Head Height to Automatic.(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.626You are printing on heavyweightpaper or paper that curls or wrinkleseasily after absorbing ink.When printing on Heavyweight Coated Paper or other paper-based media,choose a VacuumStrngth setting of Strong or Strongest in the Control Panelmenu. If the paper still rubs, set Head Height to Highest in the Control Panelmenu.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.636(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.626When printing on CAD Tracing Paper or other film-based media, choose a Vac-uumStrngth setting of Standard, Strong, or Strongest in the Control Panelmenu. If the paper still rubs, set Head Height to Highest in the Control Panelmenu.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.636(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.626The Ejection Guide is soiled. Clean the Ejection Guide.(See "Cleaning the Printer Exterior.") →P.756The surface of the paper is dirtyCause Corrective ActionThe Paper Retainer is soiled. Clean the Paper Retainer.(See "Cleaning Inside the Top Cover.") →P.756Troubleshooting > Problems with the printing quality >The edges of the paper are dirty iPF75011788
