Cannot print over a networkCannot connect the printer to the network ...................................................................................................... 795Cannot print over a TCP/IP network ................................................................................................................ 795Cannot print over a NetWare network ............................................................................................................. 796Cannot print over AppleTalk or Bonjour networks .......................................................................................... 796Cannot connect the printer to the networkCause Corrective ActionThe Ethernet cableis not connectedcorrectly to theprinter's Ethernetport.1. Make sure the printer is connected to the network with the correct Ethernet cable, and thenturn the printer on. For instructions on connecting the cable, refer to the Setup Guide.2. Make sure the Link indicator is lit.The bottom indicator is green if the printer is connected via 1000Base-T, while the top indica-tor is orange if connected via 100Base-TX and the top indicator is green if connected via10Base-T.If the Link indicator is not lit, check the following points.• Make sure the hub is on.• Make sure the end of the Ethernet cable is connected correctly.Insert the Ethernet cable until it clicks and locks in place.• Make sure there is no problem with the Ethernet cable.If there is any problem, replace the Ethernet cable.• Check the communication mode with the hub.Although the printer normally detects the hub communication mode and transmission rateautomatically (in auto negotiation mode), sometimes the hub settings cannot be detected.In this case, configure the connection method manually, specifying the communicationmode in use.(See "Configuring the Communication Mode Manually.") →P.727Cannot print over a TCP/IP networkCause Corrective ActionThe printer's IP address is notconfigured correctly.Make sure the printer's IP address is configured correctly.(See "Configuring the IP Address Using imagePROGRAF Device Setup Utili-ty.") →P.408(See "Configuring the IP Address Using the Printer Control Panel.") →P.700The printer's TCP/IP networksettings are not configured cor-rectly.Make sure the printer's TCP/IP network settings are configured correctly.(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.")→P.704The computer you are trying toprint from is not configuredcorrectly.Make sure the computer's TCP/IP network settings are configured correctly.(See "Configuring the Printer Driver Destination (Windows).") →P.703(See "Configuring the Destination in TCP/IP Networks.") →P.719Troubleshooting > Cannot print over a network >iPF750 Cannot connect the printer to the network11795
